How it is made

How it is made

How it is made

12

mm

Low-iron glass, so the edges stay clear instead of green.

6

mm

Between ribs, ground wet on a diamond wheel.

1

layer

Of ruby, laminated inside. Never more than one.

38

hours

Of workshop time inside every Veil Lounge Chair.

01 / 05

Cut.

Every panel starts as a 12 mm sheet of low-iron glass, cut to size on a water-jet table. Low-iron keeps the edges clear instead of the usual bottle green.

02 / 05

Rib.

The ribs are ground one pass at a time on a diamond wheel, cooled with water. A 160 cm panel takes 266 passes and most of a day.

03 / 05

Laminate.

One sheet of ruby film goes between two ribbed panels, then both are pressed under heat until they become one. It is the only colour we use.

04 / 05

Polish.

Every edge is polished by hand, through six grits of felt and cerium, until it carries light the way a lens does.

05 / 05

Assemble.

Brushed steel fittings, turned in Biel, hold the panels together. Nothing is glued, so any panel can be replaced in an afternoon.

Nothing is glued. Everything can be taken apart and put back.

Nothing is glued. Everything can be taken apart and put back.

Nothing is glued. Everything can be taken apart and put back.

Workshop rule no. 1, written on the wall above the polishing bench.

Workshop rule no. 1, written on the wall above the polishing bench.

Create a free website with Framer, the website builder loved by startups, designers and agencies.